KSEB Sub-Engineer Question Paper
1. The rotor of a salient pole alternator consist of ....
ANS: shaft, spider, yoke and salient poles
2. What are the methods of excitation of alternators?
ANS: Self-excited dc shut generator mounted on the extended shaft of the alternators.
3. Within first few cycles after the occurance of the short circuit on alternator, the current will be ...
ANS: ten to twelve times the full load current.
4. Turbo alternators usually have.....
ANS: 2 Poles
5. Salient pole type of rotor construction is usually provided in alternators used in .....
ANS: hydro power stations
6. Alternator of a central power station will have .....
ANS: revolving field winding
7. Where the terminal voltage of an alternator falls on throwing of the load, it indicates.....
ANS: that the load is capacitive
-->
8. In order that two alternators should run in parallel......
ANS: their speed should be in direct ratio of their number of poles.
9.Parallel operation of two synchronous alternators will be better achieved....
ANS: if both machines have less resistance than synchronous reactance.
10. Modern synchronous are designed to have high value of leakage reactance and armature reaction. This is done..
ANS: to reduce mechanical and electrical damage in the case of accidental short circuits.
11.Short circuit current of an alternator is limited by.....
ANS:the saturated synchronous impedance
12. Alternators are now a days designed to have poor regulation because....
ANS: it limits the value of short circuit current
13. Alternators in aircraft have operating frequency of ....
ANS: 400Hz
14.Frequency of 400Hz is used in air craft alternators to ....
ANS:reduce the weight of the alternators
15. Modern 3Q alternator of central power station will have generated voltage of ....
ANS: 11000 V
16. When a 3Q alternator supplies reactive load, armature reaction flux will be ....
ANS: along the axis of the field
17. When a 3Q alternator supplies incluctive load, armature reaction flux will be ....
ANS: opposing the main magnetic field
18.When a 3Q alternator supplies resistive load, armature reaction flux will be ....
ANS: at 90 degree with the field axis
19. Dampers in large generator
ANS: increase stability
20. Short-pitched coils in the alternator are used ....
ANS: to reduce the harmonics from the generated emf of the alternator
Really better than any other site. I have been searching for assistant engineer electrical pwd/irrigation previous question papers, and i am happy that i could find atleast a similar paper here.
ReplyDeleteThank you
Thank You for Your valuable Comment
Delete